Home
Главная
Moxa
Ethernet-коммутатор
IKS-G6524A-4GTXSFP-HV-HV
Руководство по созданию резервированных сетей Страница: 15

Moxa IKS-G6524A-4GTXSFP-HV-HV [15/37] Managed ethernet switch redundancy protocol ui 2 turbo ring

Moxa IKS-6728A-4GTXSFP-HV-T [15/37] Managed ethernet switch redundancy protocol ui 2 turbo ring

Managed Ethernet Switch Redundancy Protocol (UI 2.0) Turbo Ring

2-10

NOTE

The Turbo Ring DIP Switches located on the

outer casing of the EDS E series switches

can be used to configure

switch

Turbo Ring protocols (Turbo Ring or Turbo Ring V2).

If the

Turbo Ring DIP Switch is enabled from any access interface (web-based UI, console, or Telnet)

, and

the 4

DIP Switch on the switch outer casing is set to ON, the Redundancy

Protocol will be set automatically to

the

Turbo Ring protocol based on the version configured in the Turbo Ring DIP Switch page, and the

corresponding Redundant Ports, Coupling Ports

, and Coupling Control Port will be fixed to the assigned factor

default port number automatically.

In this case, you will not be able to use the web-

based UI, console, or Telnet

interface to change the status of the DIP Switch and

all settings in the Redundancy Protocol page will not

allow

ed to be configured, as shown in the following figure:

In addition

, those default Redundant Ports, Coupling Ports, and Coupling Control Port will be added

automatically to all VLANs (i.e.

, to act as “Trunk Ports”) if you set the 4th DIP Switch to the “ON”

position when

the Turb

o Ring DIP Switch is enabled. Once you flip the 4th DIP Switch back from ON to OFF

when the Turbo

Ring DIP Switch is enabled, such default Redundant Ports, Coupling Ports

and Coupling Control Port that were

added to all VLANs will be restored to their pre

vious software settings.

NOTE

If you would like to enable VLAN and/or port trunking

on any of the last four ports, do not use the fourth DIP

switch to activate Turbo Ring. In this case, you should use the Web, Telnet, or Serial console to activate Turbo

Ring.

NOTE

Turbo Ring V2 or Turbo Chain is one function of V

-ON technology that

should be enabled in layer 2 and layer 3

switches. For

a detailed introduction, please refer to Chapter 5, V-ON.

Moxa IKS-G6524A-4GTXSFP-HV-HV [15/37] Managed ethernet switch redundancy protocol ui 2 turbo ring

Содержание

Похожие устройства