MartinLogan Dynamo 700w [10/40] Ac power connection
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

MartinLogan Dynamo 700w [10/40] Ac power connection

MartinLogan Dynamo 700w [10/40] Ac power connection
10 Connections and Control Settings
AC Power Connection
WARNING! The power cord should not be
installed, removed, or left detached from
the subwoofer while the other end is con-
nected to an AC power source.
The IEC power cord should be firmly inserted into the AC
power receptacle on the rear connection panel of the
subwoofer, then to any convenient AC wall outlet. The sub
also integrates a signal sensing power supply that automati-
cally switches off after sensing no music signal for several
minutes (this will occur when the power switch is set to 'Auto').
Your subwoofer is wired for the power service supplied in
the country of original consumer sale. The AC power rat-
ing applicable to a particular unit is specified both on the
packing carton and on the serial number plate attached to
the subwoofer.
If you remove your subwoofer from the country of original
sale, be certain that AC power supplied in any subsequent
location is suitable before connecting and operating the
subwoofer. Substantially impaired performance or severe
damage may occur to the subwoofer if operation is attempt-
ed from an incorrect AC power source.
Replacing the Fuse
If the fuse in your subwoofer should require changing, turn
off and unplug your subwoofer before removing the fuse.
Replace with a matching fuse.
Break-In
Our custom made woofers require approximately 50 hours
of break-in at moderate listening levels before their optimal
performance occurs. This will factor in on any critical listen-
ing and judgment.
Optional Wireless Connection
The Dynamo 1000W and 700W subwoofers incorporate
a wireless receiver for use with the MartinLogan SWT-2
Subwoofer Wireless Transmitter. To establish a wireless
connection, connect a transmitter to your electronics and
follow these two easy steps.
1. Press the subwoofer’s sync button and hold for 3 sec-
onds. The LED will blink quickly.
2 Press the sync button on the SWT-2 transmitter and hold
for 3 seconds. The LED will blink quickly. If pairing has
completed successfully both LEDs will stop blinking and
remain on. Please note: If a link is not established
after 30 seconds this transmitter’s LED will start blinking
slowly. Repeat both steps.
WARNING! For best performance we recommend that
the SWT-2 wireless transmitter not be placed on the floor.
WARNING! When operating wirelessly this subwoofer
may be susceptible to RF interference in the 2.4GHz
bandwidth from microwave ovens and wireless devices
such as WiFi systems, video game consoles, cordless
telephones, blue tooth devices, and baby monitors.
Generally, this issue (intermittent sound or slight popping
noises) is easily resolved by physically separating prob-
lematic devices from one another—a distance as little as
two feet will often alleviate the interference. In the case of
microwave ovens, the interference will only occur when
the microwave is operating.
Figure 6. Establishing a connection between the subwoofer and the
SWT-2 Subwoofer Wireless Transmitter (included).

Содержание

Похожие устройства

Скачать