Moxa IMC-101-S-SC-80 [5/14] Din rail mounting

- 5 -

DIN Rail Mounting

The aluminum DIN rail attachment plate should be fixed to the back panel

of the IMC-101 when you take it out of the box. If you need to reattach

the DIN rail attachment plate to the IMC-101, make sure the stiff metal

spring is situated towards the top, as shown in the figures below.

STEP 1: Insert the top of the DIN

rail into the slot just below the stiff

metal spring.

STEP 2: The DIN rail attachment

unit will snap into place as shown

below.

To remove the IMC-101 from the DIN rail, simply reverse Steps 1 and 2

above.

Wall Mounting (Optional)

For some applications, you will find it convenient to mount the IMC-101

on the wall, as illustrated below.

STEP 1:

Remove the aluminum DIN rail

attachment plate from the

IMC

-101, and then attach the

wall mount plates.

STEP 2:

Mounting the IMC

101 on the wall requires 4 screws. Use

the IMC

101, with wall mount plates attached, as a guide

to mark the correct locations of the 4 screws. The heads

of the screws should be less than 6.0 mm in diameter,

and the shafts should be less than 3.5 mm in diameter,

as shown in the figure at the right.

NOTE

Test the screw head and shank size by inserting the screw into

one of the keyhole shaped apertures of the wall mounting plate.

Do not screw the screws in all the way

—

leave a space of about 2 mm to

allow room for sliding the wall mount panel between the wall and the

screws.