Moxa UC-7110-LX Руководство по программной части онлайн [13/46] 170793

UC-7101/7110/7112 Software User’s Manual Getting Started

2-5

3. You may also configure the UC-7101/7110/7112 to request IP addresses from a DHCP server.

In this case, use the sharp sign (#) to comment out one or both “ifconfig” lines, and then add

the setting about the “dhcpcd” into the rc file as below:

dhcpcd -p -a eth0 &

dhcpcd -p -a eth1 &

Note that the UC-7101/7110/7112 will send out DHCP broadcast packets, and then get the IP

addresses from the first DHCP server that responds.

4. Issue the vi “write” command to save the file, and then reboot. Since the UC-7101/7110/7112

only reads the “rc” file when booting up, you must reboot (e.g., by issuing the vi reboot

command) for the changes to take affect.

ATTENTION

You may reset the IP address immediately by issuing the command:

ifconfig eth0 192.168.5.127

(This will change the IP address of LAN1.)Issuing this command will however NOT update the

“rc” file in the UC-7101/7110/7112’s flash memory, so the next time you reboot, the IP address

will revert to its previous value.