Moxa UC-8410A-LX Руководство по быстрой установке онлайн [5/7] 170812

- 5 -

2. Remove the cover to access the SD-card slot and the mSATA socket.

3. Push the SD card in gently to release it and remove the SD card to

insert a new one in the socket. Make sure your SD card has been

securely inserted.

Please note that the SD card comes with a pre-installed operating

system. For details on Operating System recovery, refer to the

UC-8410A User’s Manual.

4. Insert the mSATA drive into the socket, and then fasten the screws.

Please note that the mSATA drive is NOT included in the product

package and must be purchased separately. Standard mSATA drive

types have been tested with the UC-8410A computer and have been

found to work normally. For additional details, refer to the UC-8410A

hardware manual.

Console Port

The serial console port is a 4-pin pin-header RS-232 port that is located

below the SD card socket. Use a screwdriver to remove the two screws

holding the cover to the embedded computer’s housing. The port is used

for the serial console terminal, which is useful for viewing boot-up

messages. Use the CBL-4PINDB9F-100 cable included with the

UC-8410A-LX to connect a PC to the UC-8410A’s serial console port. For

details on configuring the UC-8410A-LX, refer to the Connecting the

UC-8410A Computer to a PC section.

Reset Button

Self-Diagnostic: The red LED will start blinking when you press the reset

button. Keep the button pressed until the green LED lights up for the first

time, and then release the button to enter diagnostic mode.

Reset to Factory Default: The red LED will start blinking when you press

the reset button. Keep the button pressed until the green LED lights up for

the second time and then release the button to start the reset to factory

default process.

USB

The UC-8410A supports 2 USB 2.0 hosts for external storage expansion.