Moxa V2406A-C2-T [20/43] Connecting to a usb device

V2406A Hardware Manual Hardware Connection Description

3-7

ATTENTION

Make sure that you orient the CFast card properly before pushing it into the slot. The bottom of the CFast

card

must be facing up for the card to work properly, and for the CFast socket cover to be installed properly.

4. After the CFast card is installed correctly, fasten the screws on the CFast card socket cover to install it.

ATTENTION

The V2406A embedded computer does not support the CFast hot swap and PnP (Plug and Play) functions.

You

must disconnect the power source first, before inserting or removing the CFast card.

Connecting to a USB Device

The V2406A comes with one USB 2.0 host with M12 D-coded connector on the front panel and two USB 2.0

hosts with type A connectors on the rear panel. These ports can be used for connecting to an external flash disk

or hard drive for storing data. You can also use these USB ports to connect to a keyboard or a mouse.

The following figures show the locations of the USB ports and the M12 D-coded connector pin assignment.