Moxa V2616A-C8-CT-W7E [24/44] V2616a hardware manual hardware connection description

V2616A Hardware Manual Hardware Connection Description

3-11

Upgrading the Memory Module

V2616A embedded computers come with two 200-pin, DDR3-1600 SODIMM memory slots that can provide up

to 16 GB of memory. One 4 GB memory module is installed at the factory. To upgrade a memory module, follow

these instructions:

1. Disconnect the V2616A from the power source.

2. Remove the 21 screws that secure the back panel to the case. See the following figure for details.

3. Pull up the back cover of the computer; you will now

see the memory sockets on the main board.

4. Carefully remove the module by pushing the latches

on both sides of the module, freeing it to be

removed.

5. After removing the memory card, install the new

module by gently but firmly inserting it into the RAM

slot. Before securing the card in place, be sure you

have aligned the indentations on each side of the

card with the mechanical locks that will hold it in

place (shown at right, in the red circles).

Once the card is properly aligned, gently push the

card down, until it locks in place. You should hear an

audible click; before continuing, make sure the

latches are firmly in place.

6. When finished, replace the back cover of the V2616A computer.