Moxa V2416-LX [38/45] Attention

V2416 / W7E System Recovery

6-4

ATTENTION

Because of the

peculiarities of the

file tree naming, it is not possible to include both the base OS image and a

fully configured system image on the same USB stick

If users wish to configure both, then two USB drives must

be used,

each configured according to the two different alternatives offered here.

Step 2: Setting the BIOS to Boot via USB

At this stage, users will reset the BIOS so that the system boots directly from the USB. This must be done

before the rest of the system recovery environment may be configured.

1. Power on and press DEL to enter the BIOS Setup menu.

2. Select Advanced  Hard Disk Boot Priority and then press Enter.

3. From the Setup menu, use “” or “” to select the USB device.

4. Press F10 and then press Enter to save and exit the BIOS configuration interface. This should initiate the

next reboot, during which your system should now boot from the USB drive.

Step 3 (opt.): Create a Custom System Image

The instructions which follow are only to be used if you decided in Step 1of this process to create a full copy

of an already-configured system. If you have not yet installed any software on your system, then return to

section 5b of Step 1: Preparing the USB Drive and follow the instructions to create a clean OS image.

Using this procedure, you will save to the USB drive a copy of the entire system as it is currently configured

to be used as a full system recovery image should the system crash. All files under

F:\home\partimag\

will be overwritten. Additionally, you should have already changed the BIOS settings to make the USB drive

the first boot priority. If you have not yet reset the boot priority, first return to

Step 2: Setting the BIOS to

Boot via USB, just above, and follow the directions there.

1. Once the system has launched and the V2416 has booted the recovery environment from the USB drive,

navigate to the entry ClonezillaLive Save Disk, and select it by pressing Enter. This will take you into the

recovery image creation environment, allowing you to copy your full system setup to the USB drive.