Moxa MPC-2190Z [21/70] Powering on off the mpc 2190 series

MPC-2190 Hardware Hardware Connection Description

3-7

ATTENTION

This product is intended to be mounted to a well-grounded mounting surface, such as a metal panel.

Grounding: See the figure shown below for the location of the grounding connector. Connect the grounding

wire to an appropriate grounded metal surface.

Powering on/off the MPC-2190 Series

To power on the MPC-2190 Series you may connect the Terminal Block to Power Jack Converter to the

MPC-2190 Series DC terminal block (located on the bottom surface) and then connect a power adapter; or,

alternatively, you may power the device using the AC power cord. Touch the MENU button (in the lower right

corner of the display panel) for 1 second to turn on the computer. It takes about 10 to 30 seconds for the

system to boot up.

To power off the MPC-2190 Series, touch the MENU button for 4 seconds; depending on your OS’s power

management settings you may enter standby, hibernation, or system shutdown mode. If you encounter

technical problems, touch the MENU button again this time for 10 seconds to force a hard shutdown of the

system.

NOTE: If the MPC-2190 is powered using a DC converter the INFO dialog will display an Error message as the

AC power status. This will not affect the MPC-2190’s operation.

SavvyTouch Display Control Buttons

The MPC-2190 Series comes with five SavvyTouch display control buttons located on the front surface. These

intelligent controls will light up with the your hand draws near over the area of the screen where they are

located.

The MENU button operates like a power button, with which users may start up or shut down the computer.

Holding the button for 1 second will power on the system, and the button will light up a solid green. To power

off the MPC-2190, press and hold the Menu button for 4 seconds to enter standby, hibernation, or system