Autel Maxivideo MV201 8.5 мм [13/35] Charger inspection

Battery Charging Precautions Charger Inspection

4.3 Charger Inspection

CAUTION: Before using, inspect the charger and correct any

problems. Set up charger according to these procedures to reduce

the risk of injury from electric shock, fire and other causes and

prevent tool damage.

1) Make sure charger is unplugged. Inspect the power cord and

charger for damage or modifications, or broken, worn, missing,

misaligned or binding parts. If any problems are found, do not

use the charger until the parts have been repaired or replaced.

2) Clean any oil, grease or dirt from the tool especially on the

buttons. This helps prevent the tool from slipping from your

hands and allows proper ventilation.

3) Inspect if the warning label on charger’s surface is intact and

readable.

4) Select appropriate location for charger before using. Check work

area for:

 The charger must be between 41°F (5°C) and 113°F

(45°C) for charging. If the temperature of either is outside

of this range at any point during charging, the operation will

be suspended until brought back to the correct temperature

range.

 Inspect that the plug fits correctly into the desired outlet.

 The charger needs a clearance of at least 4" (10 cm) on all

sides to maintain a proper operating temperature.

4.4 Battery Charging Procedures

NOTE: New battery reaches full capacity after approximately 5

charging and discharging cycles.

The tool has a 3.7V built-in lithium-ion rechargeable battery. When

the battery is low, a “Battery critically low!” message appears and

suggests you to charge the battery in time. (Fig. 8)