Moxa ICF-1180I-M-ST [4/16] Features

- 4 -

Using Remote Fiber Diagnosis:

Set DIP switch SW8 to the ON position on any ICF-1180I converter and

then look at the Ready LED status. A flashing green Ready LED indicates

that the Fiber Test has finished. The P1 (Fiber port) LED indicates which

side (Tx or Rx) is causing the problem. If there are no fiber connection

errors in the entire topology, the related LEDs will shine green or remain

OFF. If the fiber connection error is adjacent to the converter, the status

will also be indicated by the P1 LEDs. A flashing red light on P1 means that

the Rx fiber cable connected to this port is broken. Similarly, a solid red

light on P1 means that the Tx fiber cable in this port is broken. Further

descriptions and troubleshooting can be found in the Troubleshooting

table.

Features

• Auto baudrate detection and data speed up to 12 Mbps

• PROFIBUS bus fail safe

• Alarm by relay output

• 2 kV galvanic isolation

• Power polarity protection

• Extends PROFIBUS transmission distance:

 Up to 45 km with single-mode—ICF-1180I-S series

 Up to 4 km with multi-mode—ICF-1180I-M series

• Remote Fiber Diagnosis

• Topology: Point-to-Point mode, Linear mode (as the head or tail

converter with ICF-1280I)

• Dual power inputs for redundancy

• Wide operating temperature range: -40 to 75°C (for “T” models)

• Supports Fiber Signal Intensity Diagnosis

Package Checklist

Before installing the ICF-1180I converter, verify that the package

contains the following items:

• ICF-1180I PROFIBUS-to-fiber converter

• Quick installation guide (printed)

• Warranty card

Note: Please notify your sales representative if any of the above items are

missing or damaged.