Moxa ioLogik E1240 [50/115] Using snmp

Превью страниц Страница 50 / 115

ioLogik E1200 Series Using the Web Console

3-21

Private Trap

The ioLogik E1200 series remote I/O provides the following private trap triggers:

Trigger Type Description

DI-change status Sends SNMP trap when DI status changes.

DO-change status Sends SNMP trap when DI status changes.

Relay-change status Sends SNMP trap when Relay status changes.

AI-burn-out Sends SNMP trap when AI reaches preset burn-out value.

AI-trigger Sends SNMP trap when AI reaches preset value.

AO-trigger Sends SNMP trap when AO reaches preset value.

RTD-trigger Sends SNMP trap when RTD reaches preset value.

TC-trigger Sends SNMP trap when TC reaches preset value.

Using SNMP

Moxa has provided the ioLogik E1200 MIB file for easier analysis of SNMP data.

SNMP Agent

You can enable SNMP under SNMP Settings  SNMP Agent. SNMP is used to monitor the network and I/O

devices with SNMP network management software. Use these fields to enable SNMP and set the read and write

community names, contact, and location for SNMPv1 and SNMPv2c.

SNMP Trap Settings

On the SNMP Trap Settings page, you can enable SNMP and configure SNMP traps.

SNMP Trap Server

The SNMP Trap function sends an SNMP trap to up to two IP destinations. If both IP addresses are configured,

it will send to both addresses simultaneously when an SNMP trap is triggered.

NOTE

You will

need to load the correct MIB file to use Moxa’s private SNMP traps.