M-Audio Delta RBUS Инструкция по эксплуатации онлайн [22/60] 19013

sent from your software application (or Windows) to the driver devices

with those same names. Each name begins with "WavOut" to remind you

that these are software streams and may not necessarily be routed to any

physical outputs (see Patchbay/Router Page).

ON THE MAC, these inputs are labeled “SM/ASIO,” as these software

streams will be receiving their digital audio either from the Sound

Manager or the ASIO driver, depending on your selection.

Further to the right are more channels, labeled "H/W In 1/2" through

"H/W In 7/8," and "H/W In SP/ANA." These mixer inputs are audio

streams from the physical Delta R-BUS card’s hardware inputs, hence the

"H/W" at the front of each label. These labels are consistent on both the

Mac and PC.

PAN

Each mixer input may be individually panned anywhere in the stereo

output mix. A pan control is positioned directly under each input channel

peak meter and has the appearance of a small vertical pointer. To make

a coarse adjustment, click on the pan control with your mouse and drag

it to the desired position. For finer adjustment (in 1% increments), you

may click on the pan control to make it active, and then use the left/right

or up/down cursor keys on your computer keyboard. Either way, while

the pan setting is being adjusted, its value will appear numerically in the

Master Volume’s status box (below the Master Volume Stereo Link

control) as a percentage from left pan to right pan: -100% represents

far left, +100% represents far right, and 0% represents the center.

SOLO

Each mixer input channel has a "Solo" checkbox associated with it. Clicking

on and activating a Solo box will solo the selected channel by essentially

muting all other signals. When more than one channel has Solo selected, all

solo channels will be summed to the solo ‘buss’ (path), which is what one

might consider an ‘in place’ solo as opposed to a PFL, or pre-fader listen

(levels and pans still apply). Deactivating all solo boxes will return all input

channels to their previous mute/unmute states.

MUTE

Every mixer input channel has a "Mute" checkbox associated with it.

Clicking on and activating the Mute box will remove that signal from the

stereo buss. Deactivating the Mute box will add the signal back into the

stereo buss.

STEREO LINK

All input channel pairs have a "Stereo Link" capability. Clicking on and