M-Audio Delta RBUS Инструкция по эксплуатации онлайн [51/60] 19013

Track one is now set up to record the guitar, and track two the

microphone. If your software requires this, set the software’s clock

source to ‘Audio.’

16. Press record on your software’s transport bar. Record a take of your

guitar and vocals. Understand that while recording, you are

monitoring the Delta inputs by way of the Monitor Mixer settings for

H/W In SP/ANA, and according to the selection of ‘Monitor Mixer’

within the Patchbay/Router page. At the same time, your software is

recording from H/W In SP/ANA (with Analog” selected as the active

input) but at the levels that were set up with the pre-amp.

17. When you are done playing, stop the recording software and rewind

the take. Before playing back what you’ve recorded, you will need to

assign the recorded tracks to output devices on the Delta R-BUS.

Note: For efficiency’s sake, this step could have taken place

while you were setting up the recording track assignments.

However, since this step only affects playback and does not

affect the recording setup in any way, we’ve placed it here to

lessen confusion.

Assign software track 1 to output device "WavOut SP/ANA Delta-

R-BUS" and pan the track (within your software) all the way to the

left (hard left), or wherever you find it appropriate between left and

center. Then assign track 2 to output device "WavOut SP/ANA

Delta-R-BUS" and pan the track all the way to the hard right, or

wherever you find it appropriate between right and center. Now,

when you start playback, track one (guitar) will be sent to the Delta

software (WavOut SP/ANA Left), and track two (mic) to Delta

software output 10 (WavOut SP/ANA Right). These two software

outputs are inputs to the monitor mixer, therefore the recorded guitar

and mic channels will be sent to the monitor mixer, levels will be

modified by the mixer and the output of the mixer will be heard at

the analog outputs.

18. Start playback from your software’s transport bar. Open the Delta

Control Panel and go to the Monitor Mixer page. Observe the meters at

"WavOut SP/ANA" – these are the playback levels of your guitar and

mic. Adjust the faders and mute controls so that you may hear the guitar

and mic at the appropriate levels and mix. These are the levels at which

you may monitor the pre-recorded tracks while you overdub (record

other tracks while listening to the first) additional parts.

Let’s assume that you like this take, and wish to overdub an additional guitar

and a harmony vocal. We can still use hardware analog inputs of the Delta.