Moxa VPort 364A-T [5/21] First time installation and configuration
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Moxa VPort 364A-T [5/21] First time installation and configuration

Moxa VPort 364A-M-SC-T [5/21] First time installation and configuration
- 5 -
First-Time Installation and Configuration
Before installing the VPort 364A, check to make sure that all the items in
the package checklist are in the box. In addition, you will need access to
a notebook computer or PC equipped with an Ethernet port.
Step 1: Select the Power Source
The VPort 364A can be powered by a DC power input from 12 to 32 VDC,
or an AC power input from 18 to 30 VAC. Two power inputs are provided
for redundancy. Users can check the LED status located in the front panel
to see if the power inputs are connected appropriately. If one of the power
inputs fails, the FAULT LED will light up in red if the power failure alarm is
enabled.
NOTE
The VPort 364A series supports power input specifications of
12
-32 VDC for 12/24 VDC power input, or 18-
30 VAC for 24 VAC
power input (note that this is different fro
m Moxa EDS switch’s
12-45 VDC power input).
Step 2: Connect the VPort 364A to a Network
The VPort 364A has one auto-sensing 10/100 Mbps RJ45 Ethernet or 100
Mbps fiber optic port (multi mode or single mode). An LED indicator
located on the side of each port indicates a 10 Mbps or 100 Mbps Ethernet
connection.
Step 3: Connect the VPort 364A to cameras and an audio source
The VPort 364A has four VIDEO INPUT ports (V1, V2, V3, and V4). Use the
BNC connector (1.0 Vpp, 75Ω) and coaxial cable to connect video
cameras to the VPort to input analog video signals.
The VPort 364A has one audio input and one audio output. A microphone
or an amplifier can be plugged directly into the AUDIO INPUT port, and a
speaker can be plugged into the AUDIO OUTPUT port.
NOTE
The four LEDs (V1, V2, V3, and V4) located on the VPort 364A’s
front panel indicate the video
signal transmission status for video
inputs. You may refer to these LEDs to verify video signal status.
ATTENTION
A ground loop isolator is recommended to be used between the
camera and the VPort to avoid a sudden current, which is
generated by the electric potential difference between these two
device’s ground power, to burn out the VPort’s chips and boards.
Step 4: Connecting motorized PTZ cameras and serial devices
The VPort 364A has an RS-232/422/485 PTZ port with 5-pin terminal
block connector. It can be used for connecting PTZ control cables for
controlling PTZ cameras over the TCP/IP network.
To enable PTZ control, users should configure the PTZ control protocol in
the web-based manager (web console).

Содержание

Похожие устройства

Скачать