Moxa MxNVR-IA8 [13/61] Getting started

Moxa MxNVR-IA8 Getting Started

2-2

Before Getting Started

In what follows, “user” refers to those who can access the video recorder, and “Administrator” refers to the

person who knows the root password that allows changes to the video recorder’s configuration, in addition to

providing general access. The Administrator should read this part of the manual carefully, especially during

installation.

First-Time Installation and Configuration

Before installing the MxNVR-IA8, make sure that all items in the package checklist are in the box. In addition,

you will need access to a notebook computer or PC equipped with an Ethernet port.

Step 1: Install the hard disks

The MxNVR-IA8 has two 2.5-inch hard disk sockets with SATAII interface. You will need to purchase and install

the 2.5-in hard disk (models with 0 to 60°C operating temperatures) or 2.5-in solid state disk (models with -40

to 75°C operating temperatures) into these two sockets.

NOTE To install a new hard disk, refer to the “Installing a New Hard Disk” section later in this chapter.

Step 2: Connect the MxNVR-IA8 to a Network

The MxNVR-IA8 has a built in auto-sensing 10/100/1000 Mbps RJ45 Ethernet port. A LAN LED indicator located

on the front panel indicates a 10/100 Mbps or a 1000 Mbps Ethernet connection.

Step 3: Select the Power Source

The MxNVR-IA8 can be powered by a DC power input from 12 to 32 VDC. Check the PWR LED status located on

the front panel to see if the power inputs are connected appropriately.

Step 4: Configure the MxNVR-IA8’s IP address

After powering on the MxNVR-IA8, wait a few seconds for the POST (Power On Self Test) to run. The STAT LED

turns green to indicate that the POST process has completed. When the LAN LED blinks, the IP address will be

assigned based on the network environment.

Network Environment with DHCP Server

In this case, the IP address of the MxNVR-IA8 is assigned by a DHCP Server. Use the DHCP Server’s IP address

table, or use the Moxa utility to determine the IP address that was assigned by the DHCP Server.

Using the Moxa Ethernet Switch and Video Server Configurator Utility (edscfgui.exe)

1. Run the edscfgui.exe program to search for Moxa IP video products and EDS switches. After the Utility

window opens, click Broadcast Search under the List Server menu, or click the Broadcast Search

icon to initiate a search.

NOTE

You may download the Moxa Ethernet Switch and Video Server Configurator software from Moxa’s website at

www.moxa.com.