Home
Главная
JBL
Акустические Системы
Control Now
Инструкция по эксплуатации Страница: 11

JBL Control Now Инструкция по эксплуатации онлайн [11/29] 6881

5. The mounting bracket is designed to trap the flange of the JBL Control NOW

speaker by securing the mounting-bracket cap with two screws through the

bottom of the mounting bracket. Run the loose end of the multiunit wiring

adapter through the rear cable-management hole in the mounting bracket,

and rest the JBL Control NOW speaker’s rear flange in the mounting bracket,

as shown. This will support the weight of the speaker. Now slide the mounting-

bracket cap over the assembly. Secure the mounting-bracket cap by

inserting two #10-32 x 2" screws (provided) in the bottom of the mounting

bracket and tightening.

6. Place the large end of the multiunit wiring adapter into the second speaker

to be installed. Slide the multiunit wiring adapter into the rear of the speaker

at a slight angle and rotate clockwise.

7. Connect the terminal assembly to the back of the multiunit wiring adapter.

It will snap securely into place.

8. Now connect the wires to the terminal assembly.

IMPORTANT: Make sure all equipment is turned off before making

any connections. For speaker connections, use a high-quality speaker wire

with polarity coding. The side of the wire with a ridge or other coding is

usually considered positive polarity (i.e., +).

NOTE: If desired, consult your local JBL dealer about speaker wire and

connection options.

The speakers have coded terminals that

accept a variety of wire connectors. The most

common connection is shown in the diagram

to the left. To ensure proper polarity, connect

each + terminal on the back of the amplifier

or receiver to the respective + (red) terminal

on each speaker, as shown. Connect the

– (black) terminals in a similar way. See

the owner’s guides that were included with

your amplifier, receiver and television to

confirm connection procedures.

IMPORTANT: Do not reverse polarities (i.e., + to – or – to +) when making

connections. Doing so will cause poor imaging and diminished bass response.

Wiring diagram shows

polarity connections for

one channel of a stereo or

home theater system.

9. To orient the JBL logo into the correct position, pull the JBL logo slightly

outward from the speaker grille and rotate. The JBL logo is held in place by

a spring. Peel the adhesive cover off the mounting-bracket covers and

attach to the top and bottom of the mounting assembly.

Mounting-Bracket

Covers

Mounting-Bracket

Covers

RED = +

BLACK = —

Standard

Connection

RED = +

BLACK = —

1. Strip 1/4" of wire

2. Press and push connector

3. Insert bare end;

release push connector

Already connected to the other speaker.

Mounting-Bracket Cap

Mounting Bracket

#10-32 x 2"Screws (2)

(side view)

JBLP2605_CN_CNAW_PM-OM 4/23/08 12:57 PM Page 11

JBL Control Now Инструкция по эксплуатации онлайн [11/29] 6881

Содержание

Похожие устройства