M-Audio Ozone Инструкция по эксплуатации онлайн [40/48] 19709

of your choice, send program change data from the keyboard, select the

MIDI transmit channel of the M-Audio Ozone, set the octave or pitch of

the keyboard, and program the eight rotary controllers.

DATA ENTRY Assignments: Pressing the MIDI/SELECT button then

pressing a key labeled by its MIDI function (such as velocity offset, aftertouch,

reverb depth, pan pot, volume, CC data) and then moving the data entry

slider, allows you to select the transmitting value of the chosen function.

For example, if you want to change the value of the velocity offset, first

press the MIDI/SELECT button and then the velocity key. Second, change

the data entry slider to the value you want. Finally, press the MIDI/SELECT

button again to finish the change.

To assign any MIDI control value to the data slider:

1. Press the MIDI/Select button

2. Press the CC No. key (low B)

3. Press the number keys to choose the MIDI controller number

4. Press the Enter key

5. Press the MIDI/Select button to finish your selection.

For a chart of MIDI control change values, see Appendix A in this manual.

You can also use the data slider to send this MIDI controller information

in real time. When the M-Audio Ozone powers up, the DATA ENTRY

slider defaults to a MIDI controller value of 7. A Controller 7 message is

the equivalent of a MIDI volume message. Once you’ve selected one of the

keys that represents a controller value, i.e., velocity, aftertouch, pan pot,

etc., or assigned a value using the number keys, the DATA ENTRY key then

takes on that value and will transmit that type of controller information

when the slider is moved

SET CTRL Key: Pressing the MIDI/SELECT button and then the SET

CTRL key will allow you to begin programming the rotary control knobs.

In order to change the value of each knob (1 - 8), you need to do as follows:

1. Press MIDI/SELECT, then the Set Controller key, F3 (marked “SET

CTRL.)” The display will show a small “n” to indicate that the desired

controller knob “number” should be entered next.

2. Choose the number of the desired controller knob using the number

key group (1 - 8).Then press the Enter key.The display will show a “P”

in anticipation of the “parameter” number.

3. Assign the desired MIDI controller parameter number using the

number key group (1-127), then press Enter.The display will show a “C”

in anticipation of the MIDI “channel” number. See chart, “Appendix A.”