Cisco sb slm2008t-eu [6/10] Next steps

6 Cisco 200 Series 8-Port Smart Switches

TEP 7 If this is the first time that you have logged on with the default

username and password, the

Change Password

page opens. Enter

a new administrator password and then click Apply.

CAUTION Make sure that any configuration changes that you made are

saved before exiting from the web-based interface by

clicking on the Save icon, then clicking Apply. Exiting before

you save your configuration will result in all changes being

lost.

The Getting Started window displays. You are now ready to configure the

switch. Refer to the

Cisco Smart Switch Administration Guide

for further

information.

Next Steps

• If you are not using DHCP on your network, set the connection type on

the smart switch to Static and change the static IP address and subnet

mask to match your network topology.

• Save your settings.

• Return your computer to its original settings.

These tasks can be accomplished by using the procedures in the Cisco

Smart Switch Administration Guide.

Troubleshoot Your Connection

If you cannot access your switch from the web-based interface, the switch

may not be reachable from your computer. You can test network

connections by using the ping command. The following example shows

how to use "ping" in a Windows environment:

STEP 1 Open a command window by using Start > Run and enter cmd.

STEP 2 At the Command window prompt enter ping and the smart switch

IP address. For example ping 192.168.1.254 (the default IP

address of the smart switch).

If you can reach the switch, you should get a reply similar to the

following:

Pinging 192.168.1.254 with 32 bytes of data:

Reply from 192.168.1.254: bytes=32 time<1ms TTL=128

If you cannot reach the switch, you should get a reply similar to the

following: