Pioneer plx-1000 [17/20] Additional information

En

17

Additional information

Additional information

Troubleshooting

! Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component, check the points

below and the [FAQ] for the [PLX-1000] on the Pioneer DJ support site.

http://pioneerdj.com/support/

Sometimes the problem may lie in another component. Inspect the other components and electrical appliances being used. If the problem cannot

[ON]?

No sound or small sound. Are the audio cables properly connected? Connect the audio cables properly.

Are the terminals and plugs dirty? Clean the terminals and plugs before making connections.

Is the headshell attached properly? Attach the headshell property.

The left and right sound are reversed. Are the left and right connections for each piece of

equipment reversed?

Correctly connect the audio cable and the lead wires of headshell part.

There is a low hum sound (humming

or buzzing sound) during playback.

Is there an electric device such as a fluorescent

lamp or its power cord near the connection cord?

Place the power cord of the fluorescent lamp or other device as far away as

Is the ground wire of the turntable system

Connect the ground wire properly.

Does the stylus tip have a lot of dust on it? Remove the shell with cartridge and use a soft tip brush or writing brush to care-

fully remove dust, etc. from the stylus tip.

Is anti-skating adjusted correctly? Adjust anti-skating correctly.

Is the arm height adjusted correctly? Adjust the arm height correctly.

The arm stops along the way and does

not go ahead.

Does the record have scratches? Check the condition of the record.

Is the arm coming into contact with something? Check around the arm. If there is an obstacle, remove it.

Sound volume is low or loud. Is the connection to the amplifier appropriate for

the cartridge type (output)?

Connect the connection cables properly.

Let the unit stand for 1 to 2 hours at room temperature (though this

time depends on the conditions of the condensation) without turning on

the power. The water droplets will evaporate and the unit will become

playable. Condensation can occur in the summer as well if the unit is

exposed to the direct wind from an air-conditioner, etc. If this happens,

move the unit to a different location.

Use the original packing materials to pack the unit.

If the original packing materials are not available, be sure to perform the

! Wrap the main unit in a blanket or soft paper so that it will not be

When attaching and detaching the headshell, turn off the power of the

If you attempt to do so while the volume is loud, the speaker could be

! Remove the shell with cartridge and use a soft tip brush or writing

brush to carefully remove dust, etc. from the stylus tip.

! Use a good quality record cleaner to clean records.