Ardo OBA 606 O — подключение однофазного электричества для духовок [23/84]

CONNECTION TO MONO PHASE ELECTRICITY Ovens equipped with tri polar power supply cables are constructed to function with alternating current and with the voltage and frequency indicated on the technical label on the appliance Assembly of the power cable 1 Open the terminal board by placing a screwdriver under the side flaps on the cover pull and then open the cover see the figure 2 Install the power supply cable unscrew the screws on the cable grip and the three screws on contacts L N and then attach the wires under the screw heads respecting the colours Blue N Brown L Green Yellow see the figure 3 Attach the cable to the appropriate cable holder 4 Close the terminal board cover Attaching the power supply cable to the mains For direct connection to the mains power it is necessary to use a device that ensures that the mains power is disconnected with a distance between contacts that allows complete disconnection in compliance with surge category III and installation regulations Assemble a standard plug for the capacity indicated on the rating label If the oven has a direct connection to the mains electricity supply it is necessary to install an omnipolar switch between the appliance and mains power with a minimum opening between the contacts of 3 mm dimensioned for the indicated capacity and in compliance with currently enforced regulations the switch must not interrupt the ground cable The power supply cable must be positioned in such a way that it does not exceed the room temperature by 50 C at any point The installer is responsible for correctly hooking up the electricity connection and adherence to safety regulations 21