Ardo OBA 606 O — правила подключения и установки встроенной техники [24/84]

Before hooking up to the mains supply make sure that the socket has a ground connection and complies with legal regulations the socket is able to withstand the oven s maximum power capacity indicated on the rating label also see below The power supply voltage is within the values listed in the electrical characteristics label see below the socket is compatible with the appliance plug If this is not the case replace the socket or the plug Do not use extension cords or multiple sockets Once the appliance is installed the electrical cable and the electrical power socket must be easy to reach The cable must not be bent or compressed The cable must be periodically checked and only replaced by authorized technicians The Company declines all responsibility if these instructions are not adhered to Replacement of the power cable If the power cable needs to be replaced use cables of the following type only H05 RR F H05 V2V2 F T90 which are suitable for the operating capacity and temperature The green yellow ground cable must be longer than the other two conductors by approximately 2cm INSTALLATION Important any adjustments maintenance etc must be executed with the oven disconnected from electricity To guarantee proper operation of the built in appliance the furniture unit must have suitable characteristics the panels adjacent to the oven must be constructed in heat resistant materials in the case of veneered wood furniture units the glue must be heat resistant to temperatures upto 100 C The oven must be located in a standard opening of 410mm as shown in the first page of the booklet whether under a counter or in a column position When inserting the oven into a column it is indispensable to ensure adequate ventilation by installing openings as illustrated in the figure The oven is secured to the furniture unit by four A screws located in the holes of the frame Make sure not to lift the oven by its door when inserting it furthermore do not place excessive pressure on the door when it is open Note if no opening has been anticipated in the upper part of the column furniture make a hole in the lower part of the column as shown in the drawing 22