Sven HT-500 [22/26] User s manual

USER’S MANUAL

For PCM signal delay time adjustment is as follows:

• Press the R-DLY on the remote controller, RL&RR indicator will light up.

• Press the R-DLY + or R-DLY - to adjust the required delay time.

Remark:

The delay time range of Dolby Digital 5.1 The delay time range of PCM

1. Centerchannel delay: 0–5 ms

Rear channel delay: 15–30 ms

2. Rear channel delay: 0–15 ms

Testing Channel Connection

Set up the system in 5.1 mode first, then press the TEST button. A Pink noise will appear alternatively in the sequence

of FR-C-FL-RR-RL-SW.

• If no sound or queer noise is heard in a particular channel during the test, double check the wiring or VOL- button.

• During the test you may adjust the level of various channel using the VOL+ or VOL- button.

• To cancel the test, press the TEST button again.

Remark:

• The subwoofer of this system is always on, and can not be turned off.

• When a certain channel is under test, the corresponding indicator will blink.

Adjusting Dynamics Range

You may choose a dynamic range by pressing the DR button on the remote controller. There are four setting choices:

0%, 25%, 50%, 75% and 100%.

Listen

• When the signal is DTS or Dolby Digital, Press the LISTEN button on the remote controller to select 2.1CH or 5.1CH

(STEREO) effect.

• When the signal is PCM, Press the LISTEN button to select 2.1 CH 5.1CH (STEREO), PL II M USIC or PL II MOVIE.