Alpine X800D-V [14/148] Installation

Alpine X800D-V447 [14/148] Installation
ALPINE X800D QRG 68-24567Z63-A (EN)
12-EN
Owners manual Installation
Installation
When making connections to the vehicles electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads to
provide power for this unit. When connecting the X800D
to the fuse box, make sure the fuse for the intended
circuit of the X800D has the appropriate amperage.
Failure to do so may result in damage to the unit and/or
the vehicle. When in doubt, consult your dealer.
The Display must be completely retracted in the casing
when installing. If it is not, problems may occur.
1 Before installing, make sure that the
opening and closing of the display will not
interfere with operation of the gear shift.
Movable Display
2 Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
0-30°
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
SPST SW (Optional)
X800D
ACC
(Red)
BATTERY
(Yellow)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold
separately).
The diagram and the fuse amperage shown above are in the case when X800D is used individually.
If the switched power (ignition) lead of the X800D is connected directly to the positive (+) post of the vehicles battery, the
X800D draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the
battery may be discharged.
Con
Conne

Содержание

Скачать
Случайные обсуждения

Ответы 1

Кнопка питания.
3 года назад

Ответы 0

Настроить мультируль.
7 лет назад

Ответы 1

Как извлечь диск из устройсьва
3 года назад