Home
Главная
Star
Радар-Детектор
Pro 40
Инструкция по эксплуатации Страница: 14

Star Pro 40 [14/15] Care and maintenance

TROUBLESHOOTING

If the detector does not turn on :

Check the power cord. Be sure all power connectors are properly installed.

Check the fuse that controls power to the cigarette lighter socket. See your vehicles owner's manual

The cigarette lighter socket might be dirty. Clean it with fine emery cloth to ensure a good, clean

connection.

Vehicle electrical problem exists.

Make sure that the volume control is in the ON position.

Caution:

Do not place any metal object other than the cigarette lighter or a cigarette lighter plug in the

cigarette lighter socket.

This might cause blow up the fuse in your vehicle or cause the metal object to become very hot.

If the detector gives a false alert when the vehicle hits bumps:

Check the vehicle's electrical system, including main battery cable and alternator connections.

Install a filter capacitor (470uF.35volts) on the back of the cigarette lighter socket, across the power

connections.

If the receiving signal is weak :

Check the angle of detector.

Point to the horizon.

Radar antenna / laser sensor is obstructed.

Relocate the detector clear of any obstruction outside the windshield, such as a wiper blade.

Relocate the detector clear of the window tint.

CARE AND MAINTENANCE

Your STAR PRO40 is an example of superior design and craftsmanship.

The following suggestions will help you to care your detector so you can enjoy it for years.

Never leave the detector on the windshield or dashboard when you park your vehicle. The temperature in

the vehicle in summer can reach levels above what is considered to be safe for this detector.

To make you less susceptible to break-in and theft, remove the detector from your windshield or

dashboard when you leave your vehicle.

Do not expose the detector to moisture. Rain dew, road splash, or other liquids can damage the internal

components and reduce sensitivity of the detector.

SPECIFICATIONS

RADAR

Receiver Type: Dual Conversion Superheterodyne

Antenna Type: Linear Polarized. Self-Contained Antenna

Detector Type: Scanning Frequency Discriminator

Frequency of Operation: X-Band 10.525GHz ±25MHz

Ku-Band 13.45GHz ±25Mhz

K-Band 24.15GHz ± 100MHz

Ka-POP 33.8 GHz

Ka-Band 34.7GHz ±1.3GHz

LASER

Receiver Type: Pulsed Laser Signal Receiver

Detector Type: Digital Signal Processor With Discriminator

Opto Sensor: Convex Condenser Lens and High Speed Photo Diode

Detector

Spectral Response: 800~1,100nm

GENERAL

Temperature Range: -4 to 158°F(-24 to +70°C)

Power Requirements: 12~16V DC, 310mA (Negative Ground)

Dimensions (LxWxH) 115.6 х 73.9 х 37mm

Weight: 134g

Specifications are typical;

Individual units might vary.

Specifications are subject to change without notice.

Star Pro 40 [14/15] Care and maintenance

Содержание

Похожие устройства