Schaub Lorenz SLUS445W3M [15/40] Installation instructions and door reversibility

Schaub Lorenz SLUS445W3M [15/40] Installation instructions and door reversibility
EN - 15 -
Installation instructions and door reversibility
Installation
! It is recommended that this installation be performed
by authorized technical stu.
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See g.A for the necessary attachment components.
2. Open the package. Take gasket spacer⑨ and brake
into three as shown in gure.D. The middle part is
door hang rail⑩. The other two parts are unit door
spacers⑪. (g.D)
3. Insert trim ap① into slot and screw by screws⑧.
(g.E)
4. Pass the power cord through ventilation shaft and
position it so that the appliance could be easily
plugged in once it has been installed. (g.B - g.C)
5. Cut trim gasket④ to the height of the recess and stick
it on reverse side of the door hinges of the appliance.
(g.E)
6. Raise the appliance and slide into the kitchen unit.
7. Lean the appliance to the kitchen unit through the hinges and align the front feet with front
surface of the kitchen unit. (g.F)
8. Open the appliance doors and screw the front feet by using screws⑦. (g.G)
9. Screw trim ap① to kitchen unit using screws⑦. (g.G)
10. Screw the hinges to the kitchen unit using screws⑦. (g.G)
11. Close the appliance doors. Unscrew and take out the nuts⑭, washers⑬ and adjustment
bolts⑫ from the appliance upper door⑲. (g.H)
12. Take out the liners of the tapes on door hang rails⑩. Place door hang rails⑩ on the
appliance upper door⑲ by inserting the bosses on the holes of the appliance upper
door⑲, aligning the front surfaces of the door hang rails⑩ and appliance door parallel.
Let the door hang rails⑩ stick onto the appliance upper door⑲. (g.H)
13. Slide the door hang② into door hang rails⑩. (g.J – g.K)
14. Take out the liners of the tapes on the front side of the door hang②.
15. Take out the liners of the tapes on the unit door spacers⑪ and and stick them onto the
unit upper door⑮, closer to the upper corners. (g.K)
16. Lean the unit door⑮ to the door hang②, aligning the unit door spacers⑪ on the left,
right and top edges with the sides of the unit or the doors of the nearer and upper kitchen
units. (g.K)
17. Make sure that the unit upper door⑮ sticks onto the door hang②. Pull the unit door⑮
allowing the door hang② slide out the door hang rails⑩. Observe that the door hang②
stays sticked on the unit upper door⑮. (g.L)
18. Lay down the unit upper door⑮ to the oor and screw the door hang② to the unit upper
door⑮ by screws⑦. (g.L)
Figure.B
Figure.A

Содержание

Скачать