Beko HIZG 64125 CR [11/44] Installation and connection

Содержание

Room ventilation All rooms require an openable window or equvalent and some rooms will require a permanent vent as well The air for combustion is taken from the room air and the exhaust gases are emitted directly into the room Good room ventilation is essential for safe operation of your appliance If there is no window or door available for room ventilation an extra ventilation must be installed The appliance may be located in a kitchen kitchen diner or a bed sitting room but not in a room containing a bath or shower The appliance must not be installed in a bed sitting room of less than 20m3 Do not install this appliance in a room below ground level unless it is open to ground level on at least one side Room size smaller than 5 m3 5 m3 to 10 m3 Ventilation opening min 100 cm2 mln 50 cm2 greater than 10m not regeren In the cellar or basement min 65 cm2 Installation and connection Product can only be installed and connected in accordance with the statutory installation rules Electrical connection Connect the product to a grounded outlet line protected by a fuse of suitable capacity as stated in the Technical specifications table Have the grounding installation made by a qualified electrician while using the product with or without a transformer Our company shall not be liable for any damages that will arise due to using the product without a grounding installation in accordance with the local regulations DANGER The product must be connected to the mains supply only by an authorised and qualified person The product s warranty period starts only after correct installation Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons DANGER The power cable must not be clamped bent or trapped or come into contact with hot parts of the product A damaged power cable must be replaced by a qualified electrician Otherwise there is risk of electric shock short circuit or fire Connection must comply with national regulations The mains supply data must correspond to the data specified on the type label of the product Type label is at the rear housing of the product Power cable of your product must comply with the values in Technical specifications table DANGER Before starting any work on the electrical installation disconnect the product from the mains supply There is the risk of electric shock FJ l Power cable plug must be within easy reach I 1 latter installation do not route it above the zJhob Plug the power cable into the socket Gas connection DANGER Product can be connected to gas supply system only by an authorised and qualified person Risk of explosion or toxication due to unprofessional repairs Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons 11 EN

Скачать