Home
Главная
Siemens
Стиральные Машины
WM14Q471DN
Инструкция по эксплуатации Страница: 4

Siemens WM14Q471DN [4/6] Removing the transport braces

a

Removing the transport braces

– Before using the appliance for the first time, make sure that you

completely remove transport braces and keep them for

subsequent transportation.

– If you need to transport the appliance at a later date, always re-affix

the transport braces to prevent damage to the machine. apage 6.

– Store the screw and sleeve together.

1. Take the hoses out of the holders.

2. Remove all 4 screws completely.

3. Remove all 4 transport braces completely and take the mains cable

out of the holders (depending on model).

4. Affix the covers.

Water connection depending on model

– Risk of electric shock. Do not immerse the Aqua-Stop safety device in water

(contains an electric valve).

– To prevent leaks or water damage, observe the instructions in this section.

– Caution: only operate the washing machine using cold drinking water (in case of models

featured for hot water: maximum temperature 60 ºC).

– Do not connect to the mixer tap of an unpressurised hot-water boiler.

– Do not use a used inlet hose. Only use the inlet hose supplied or one which was

purchased from an authorised specialist dealer.

– If in doubt, have a technician connect the appliance.

Water connection depending on model

Water inlet

Caution: do not bend, squash, modify or cut through

(otherwise its strength is no longer guaranteed).

Optimum water pressure in the supply network: 200ä1,000 kPa (2ä10 bar)

– When the tap is on, the water flow is at least 10 l/min

(1-2 bar: 6 l/min; with 1 bar consumption parameters cannot be assure).

– If the water pressure is higher than this, a pressure reducing valve must be installed

Connection to the tap:

Aqua-Stop, Aqua-Secure, Standard:

Connection to the

machine:

AquaäStop, Aqua-Secure Standard

no necessary with Aqua-

Stop, fixed installation;

Aqua-Secure, Standard

1. Connect the water inlet hose (hoses) to the tap (taps) 3/4" = 26,4 mm and to the solenoid

valves.

Caution: only tighten the screw connections by hand.

2. Open the water tap (taps) carefully, checking the leak tightness of the connection points.

Caution: the screw connection is under mains water pressure.

Connection in case of hot water

models:

COLD – Cold water

HOT – Hot water max. 60 °C (red)

If no hot water connection is present:

– only connect the cold water inlet hose

and

– cover the hot water connection on the

appliance so that it is kept free of dirt.

Water outlet

Caution: do not bend or pull lengthways.

Height difference between the installation surface and the

drain:

min. 60 cm - max. 100 cm

Outlet in a sink:

Caution: secure the drain hose from slipping out.

Caution: the plug must not block drainage from the sink. During

pumping, check whether the water is draining away quickly

enough. The end of the drain hose must not be immersed in the

water pumped out. This risks water being sucked back into the

washing machine.

Drainage into a siphon:

Caution: the connection point must be secured with a hose

clamp, Ø 24-40 mm (exclusive dealers).

max.

90°

max.

90°

Siemens WM14Q471DN [4/6] Removing the transport braces

Содержание

Похожие устройства