Соэкс Импульс [40/52] Instrument operation

-40-

Instrument operation

1. It is recommended to read this manual carefully.

2. Install batteries (page 30, 36)

3. Switch on the instrument.

4. It is recommended to carry out individual instrument tuning before

measurements (page 35)

5. When turned on, the instrument automatically enters "EMF in LIVE

BUILDING" measurement mode. The first measuring result appears on the

screen approximately in 10 seconds, and then a new measuring cycle starts.

The measurement is carried out uninterruptedly until the instrument is

switched off regardless of its mode.

In order to obtain the most accurate results, the measurements

should be carried out in the following way:

● EMF in LIVE BUILDING

Turn off all home appliances, including local lighting, i. e. table

lamps, sconce, etc. Turn off the general illumination.

Put the instrument into the monitored area with upper side

pointing toward the wall, holding it with your fingers at arm's length. The

measurements shall be taken at a distance of 20 cm from the walls ad

windows and at a height of 0.5–1.5 m from the floor level.

Electric field (E) reading is displayed in the left side of the

indicator display. If the "HIGH LEVEL OF ELECTRIC FIELD" message

appears on the red background, it means that electric field level is increased

and reasons for it should be searched for.

Turn on the general illumination then, and take measurements in

the same points, however, only excess of magnetic field (B), which is

displayed in the right side of the screen, should be analyzed. If the " HIGH

LEVEL OF MAGNETIC FIELD" message appears on the red background, it

means that magnetic field level is increased and reasons for it should be

searched for.

While taking measurements, one should take into account that

data is updated approximately every 10 seconds, therefore the result should

be read out not earlier then 10 seconds after placement of indicator in the

monitored area.