ORAS Electra 6134 [15/52] After flow time factory set to 1 second

After-ﬂow Time (factory-set to 1 second)

– After-ﬂow time can be adjusted using the Oras Data Terminal (v. 2.4 or later).

Cleaning the Filter (see Figure 2)

If the water ﬂow has decreased, this may be because the ﬁlter is clogged. Clean the ﬁlter as follows:

– Shut off the water supply to the faucet.

– Unscrew the strainer (18) from the valve housing.

– Clean the strainer under running water.

– Screw the strainer back.

Changing the temperature regulator (see Figure 5)

Troubleshooting

Symptom Cause / Solution

Water ﬂow from the outlet does – The sensing range is too low

not stop, or stops after 2 minutes – Check that the photocell is clean

– The solenoid valve is damaged

Water ﬂow is low and weak – Filter is clogged

No water comes out of the faucet – Check the water supply to the control box

– The solenoid valve is damaged

– Power failure

– The photocell is covered or damaged

– 6105: the showerhead is not placed

properly in its wall bracket

– Check the fuse (17) inside the control box:

6104 and 6105: 0.1 A

6134: 1 A

15 (52)