Vitek VT-1818 GY [4/36] English

Vitek VT-1818 GY [4/36] English
4
ENGLISH
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
ASSEMBLING OF THE VACUUM
CLEANER
After unit transportation or storage at
low temperature it is necessary to keep
it for at least two hours at room tem-
perature before switching on.
Unpack the vacuum cleaner completely
and check it for damages. Do not use
the unit in case of damages.
Before switching the unit on, make sure
that your home mains voltage corre-
sponds to the vacuum cleaner operat-
ing voltage.
To install the handle (1) press and hold
the handle clamp (2), insert the handle
(1) into the unit body, release the clamp
(pic. 1).
Install the attachment (8 or 11) in the dust-
bin (7) opening (pic. 2). When using the
crevice nozzle (11) remove the handle (1),
having pressed and holding the clamp (2)
and use the unit as a portable vacuum
cleaner, holding it by the handle (9).
ATTACHMENTS
Before installing or removing the attach-
ments, switch the vacuum cleaner off
and unplug it.
Universal brush (8) with “carpet/floor”
switch
Set the switch on the brush (8) to the
required position (depending on the type
of the surface being cleaned).
Crevice nozzle (11)
The crevice nozzle (11) is intended for
cleaning of radiators, chinks, corners ans
spaces between cushions.
OPERATION
Do not use the vacuum cleaner near
hot surfaces, ashtrays and in the
places where inflammable liquids are
stored.
Take sharp objects away before clean-
ing to prevent unit damage.
Attention! Do not use the vacuum
cleaner, if the cloth filter (6) and
foam filter (5) are not installed in the
dustbin (7).
To switch the vacuum cleaner on or off,
press the On/Off button (3).
After the end of operation switch the unit
off and unplug it.
Wind the power cord on the holders (10)
(pic. 3); use the plastic clamp and fas-
ten the last cord loop to any other loop
to avoid the cord unwinding.
CLEANING AND CARE
Remove garbage and dust from the
dustbin (7) and clean the filters (5,
6) after every usage of the vacuum
cleaner.
Detaching of the dustbin (7) and
removing of dust and garbage from it
Switch the unit off and unplug it.
Remove the installed attachment (8 or
11).
Press the clamp (4) and detach the
dustbin (7) from the motor unit (pic. 4).
Place the dustbin (7) above the trash
bin, remove the filter (6).
Remove dust and garbage from the
dustbin (7).
Take the foam filter (5) out of the filter
(6).
Clean the cloth filter (6) of dirt and dust.
If necessary wash the dustbin (7) and
dry.
You can wash the foam filter (5) and
cloth filter (6) under warm running
water, and before installing the filters (5
and 6) make sure that they are dry.
Note: Do not use a dish washing machine
for washing the filters (5 and 6).
VT-1818_IM.indd 4 25.01.2013 12:15:38
Скачать
Случайные обсуждения

Ответы 0

Как разобрать?
5 лет назад