Vitek VT-3534 [7/20] Alarm setting

ALARM SETTING

i. Select Alarm 1 ( 1) or Alarm 2 ( 2) by pressing MODE

ii. Press HOUR to set the hour and MINUTE to set the minute

iii. Press ALARM/(C/F) to enable or disable

the alarm function

• The alarm clock is last for 2 minutes and will

be repeated 5 minutes later when

MODE/SNOOZE key is pressed.

SETUP

Automatic Learn Function:

1. Learn function executes automatically and runs for approximately 3 min-

utes when batteries are first installed in the receiver.

2. Within these 3 minutes, receiver picks up the temperature & humidity sig-

nals from remote transmitter and displays the readings.

Manual-Learn (Searching for Remote Signals):

If a new remote transmitter is added or if signal is lost (outdoor display blink-

ing), learn function must be executed again.

1. Press & hold CHANNEL for 3 seconds to

start.

2. Beep sound indicates that learn function

has started.

3. Channel symbol will flash and unit will beep

as each remote sensor is detected.

4. Temperature readings of remote transmitter

displays on the receiver.

ENGLISH

3534.qxd 22.09.2004 15:22 Page 6