Liebherr IKS 2254 [2/4] Installation instructions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Liebherr IKS 2254 [2/4] Installation instructions

Liebherr IKS 2254 [2/4] Installation instructions
4
IKS
Installation instructions
Keep the installation instructions in a safe place and pass them
on to the next owner of your appliance where applicable.
The
operatinginstructionsapplytoseveralmodels.Dier-
encesmaythereforeoccur.
You additionally require the following tool for installation: Screw-
driver Torx
®
15, 20, 25, 30
Changing over door hinges
Fig.A1.The door hinges can be changed from one side to the
other if need be. Otherwise continue from "Installation informa-
tion", Fig B.
W
Fig.A1
1, 2 in a forward direction.
W Unscrew the hinge pin
3.
W 
W Unscrew hinge 4 and screw it on again at the opposite side
using the same screws.
W Relocate the lower hinge pin 5 with washer 6.
W If the appliance has a freezer compartment, now change the
compartment door.
(see "Changing the compartment door")
W Fit the door back in place: at the bottom place door on hinge
pin
5, at the top pass hinge pin 3 through outer hole in the
hinge into the door bearing and tighten.
W
Rotate cover parts through 180° and re-attach them to the
other side.
Changing the compartment door
W Fig.A2: At the hinge 1 fold away the cover.
Unscrew the hinge
1 and remove the compartment door
with the hinge.
W
Unscrew the closure
2.
W Close the holes with the plugs
3.
W Rotate the door and closure by 180° and replace on the
other side: Insert the compartment door at the top, put the
hinge
1 in place at the bottom, screw down again and close
the cover.
Installation information and dimensions
W Fig. B: Align the unit with a spirit level and an angle. If neces-
sary, level out by building up from underneath. The shelf and
side walls of the unit must be at right-angles to one another.
W
Fit the refrigerator/freezer in stable kitchen units only.
W
The following ventilation dimensions must be observed:
- The depth of the ventilation channel at the rear of the unit
must be at least 38 mm.
-
There must be a ventilation space of at least 200 cm
2
under-
neath and at the top of the unit. the greater the area the more
economically the appliance will run.
W
Check installation dimensions in accordance with Fig. B :
Appliance height (carcass) = a, recess height = b
W Route the mains cable with the aid of string 1 in such a way
that the appliance can be easily connected after installation,
Fig.B
Connecting to the mains
Powersupply(AC)andvoltage
at the operating point must comply with the details on the type
plate. It is located inside the appliance on the left-hand side.
W
Theappliancemustbeconnectedwithaproperlyin-
stalled
fusedsocket.
W The fuse of the plug has to be 10 A or more, it must be situ-
ated away from the rear area of the appliance and be easily
accessible.
W
Do not
- connect to stand-alone inverters,
-
operate with so-called energy-saving plugs - this can dam-
age the electronic system.
-
connect together with other appliances using an extension
cable - danger of overheating.
W When removing the mains cable from the back of the appli-
ance, remove the cable holder to prevent vibration noise.
*

Содержание

Похожие устройства

Скачать