Bork CH BRM 1918 SI [22/24] Operation guide

Oscillating ceramic heater with thermostat CH BRM 1918 SI

OPERATION GUIDE

1 2 3

Control panel

1. Power & Mode Knob

2. Oscillation button

3. Thermostat Knob

The heater may be operated by the manual controls located on the

heater.

1. Carefully remove the heater from the bag and the carton.

2. Make certain the unit is in the off (•) position before plugging the

heater into the power outlet.

3. The heater must be placed on a firm, level surface.

4. Plug the cord set into a 220-240V electrical outlet. Be sure plug

fits tightly in outlet. A loose fit will cause overheating and damage

the plug. Plug and cord set may feel warm during normal usage.

5. Turn the Power & Mode knob to the desired heat setting. Low

heat (1100W) is represented by the (

) and high heat (1800W)

by the (

6. For fan-only operation, without any heat output, turn Power & Mode

knob to the fan setting (

7. Press Oscillation button, the heater will oscillate back and forth.

Press it again and the oscillation will stop.

8. To disconnect heater, turn Power & Mode knob to the off operation

(•). Then remove the plug from outlet.

9. For heater operation, set the Thermostat Knob to the maximum

setting (

10. The power light will remain lit until the unit is turned off.