Castel MAC E15-40 P Инструкция по эксплуатации онлайн [13/32] 272676

•

BLAST FREEZING (-18°C)

This function freezes the product completely to a temperature of -18°C in less than 4 hours.

The rapidity of the process prevents formation of macrocrystals essential to ensure that the

product retains its original consistency and quality when thawed for consumption.

• AUTOMATIC CONSERVATION

At the end of each cycle (chilling or freezing), the appliance will automatically switch to the

required storage temperature.

Two different end-cycle modes are available for each cycle:

• BY TEMPERATURE - the cycle ends when the probe reaches the required temperature.

• TIMED - cycle length is pre-set

IMPORTANT: work cycles and modes can only be selected when the appliance is ON (LED

on push -button 6 off)

5.2 SOFT BLAST CHILLING BY TEMPERATURE (pre-cooked, hot foods)

• To select this cycle, press push-button 2 (relative LED lights up), then press push-but-

ton 5 to select the temperature mode (LED 5A on)

• Insert the core probe into the core of the product to be chilled.

• Start up the cycle by pressing push-button 6 . LED 5A and those relative to the push-

buttons pressed illuminate throughout the cycle, while LEDs 13 flash.

• Display 15 indicates the maximum blast chilling time (starting temperature to end of

the blast chilling temperature - factory setting - 90 minutes).

• The temperature measured by the core probe is shown by display 16 .

• The instrument timer starts the countdown of the maximum blast chilling time as soon as the

temperature measured by the core probe falls below the temperature of +65°C (the dot at

the bottom right of display 15 flashes).

• During the blast chilling cycle, the air temperature is around 0°C.

This function is designed to guarantee uniform cooling of the product, preventing frost for-

mation on the surfaces. During the blast chilling cycle, the compressor may therefore stop

and restart, depending on the reading of the cell temperature probe.

• The blast chilling phase ends only when the core probe (inserted in the product core) indi-

cates that the set blast chilling temperature (+3°C) has been reached as signalled by an

intermittent beep for a minute. During the beep, LEDs 13 and 14 flash.

Display 16 indicates the temperature inside the cell, while display 15 shows

blast chilling time reset to zero.