Castel MAC E15-40 P Инструкция по эксплуатации онлайн [14/32] 272676

• If at the end of the maximum blast chilling interval the core probe continues to display a tem-

perature higher than the value for the end of blast chilling, the displays will indicate an alarm

for excessively long chilling (ALL 14) alternating with the temperature and time; at the same

time, the alarm beep will be activated.

The blast chilling cycle continues until the end chilling temperature has been reached; dis-

play 15 counts back the minutes remaining until the end of the cycle.

NB: Press push-button 8 to mute the alarm; press push-button again to clear the

alarm display

• At the end of the chilling cycle, the appliance automatically switches to the set storage tem-

perature for an indefinite interval (like a standard storage appliance).

NB: LEDs 13 switch off while LEDs 14 light up.

• The cell temperature is constantly shown on display 16 ; during this cycle, defrost

cycles are performed at regular intervals with duration set as required (parameter pro-

gramming reserved for installation technician). The factory setting for positive storage tem-

perature is +2°C.

• Press push-button 6 to set the appliance to STOP status (relative LED switches off),

ready for a new cycle.

To modify the final blast chilling temperature, consult the user programming instructions.

5.3 SOFT TIMED BLAST CHILLING

• Press push-button 2 (relative LED lights up), then press push-button 5 to select

the timer mode (LED 5B on). Display 15 shows the maximum chilling time (set by

default to 90 minutes).

To modify this time, press push-buttons 7 and 8 (time in minutes).

• Press push-button 6 to start the appliance. LED 5B and push-button LEDs remain

on and LEDs 13 flash throughout the cycle.

• Internal cell temperature is shown on display 16 .

• When the maximum chilling time has counted back to 0, the chilling cycle is completed and

the appliance automatically switches to the set positive storage temperature for an indefi-

nite interval.

• LEDs illuminate and the beep is activated when the cycle is finished (as in the chilling cycle

by temperature). The same applies for the positive storage function.

Press push-button 6 to set the appliance to STOP status (relative LED switches off),

ready for a new cycle.