TEFCOLD CK7210 без борта (внутренний агрегат) [14/39] Defrosting

Thermostat

The thermostat is placed in the control panel, see fig. 2.0.

Fig. 2.0

The thermostat has been pre-set and in most cases it is not necessary to adjust the settings.

When turning on the cabinet the display will show the current temperature in the cabinet.

Display set temperature:

Press this key and the display will show the set temperature. Press the key again to return to

normal reading

Set new temperature:

Press this key continuously for more than 3 seconds and the display shows the set

temperature.

Press this key to increase the set temperature.

Press this key to lower the set temperature.

Press this key to save the new settings. The display will flash with the new value and will

then return to normal reading.

Alarm codes:

‘P1’ Flashing in the display: indicates that the cabinet sensor is defective.

The cabinet will strive to keep the set temperature until it has been repaired.

‘P2’ Flashing in the display: indicates that the evaporator sensor is defective.

This does not influence the operation of the cabinet, but should be repaired as soon as

possible.

Defrosting

The cabinet defrosts automatically with pre-set intervals. If the door to the cabinet is opened or the

contents of the cabinet is changed frequently it may become necessary to defrost the cabinet

manually.

Pressing this key continuously for more than 3 seconds will start a manual defrosting and

then return to normal operation.

Defrosted water runs to a container placed in the compressor compartment and evaporates.