Elcold PRO 21 Инструкция по эксплуатации онлайн [5/18] 275990
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Elcold PRO 21 Инструкция по эксплуатации онлайн [5/18] 275990

Elcold PRO 21 Инструкция по эксплуатации онлайн [5/18] 275990
User Instructions Low Temperature Freezers Model PRO/XLT
6. Setting up the freezer.
The freezer should not be placed where it
might be splashed with water, in extreme
high humidity or in direct sunlight. Any of
these factors may lead to a reduction in
performance and shorten the life span of
the components. The freezer should be
placed on a horizontal level, and should
not be placed close to a heating appliance
or heating tubes. Allow a minimum of 50mm
(2”) clearance on the side and the back.
The side with the ventilation grill should have
a clearance of at least 100 mm (4”) in order
to allow the heat from the compressor
motor to dissipate. Underneath the appli
-
ance there should be a gap of 15 mm ap
-
prox. (1⁄2”). On a soft surface, e.g. carpet,
it may be necessary to ensure the correct
distance by means of spacers.
7. Electrical supply.
The electrical supply should always be in
accordance with the rating plate on the
back of the freezer.
The supply must always be in accordance
with the law and regulations regarding
electrical safety, if any doubts contact your
supplier.
8. Starting Up.
In case the compressor does not start when
the freezer has been plugged in, the electri
-
cal supply may not be in order. Check if
there is an electricity supply to the plug or if
the fuse is blown. If not please go to trouble
shooting page 6. 18.
9.Operating the freezer
The empty freezer should be switched on
for at least 5-6 hours prior to loading of the
freezer. The freezer should not be loaded
above the inside walls which is also the load
line limit.
Please note: After the lid has been opened,
there will be a vacuum created inside the
freezer due to the low temperatures. Wait a
few minutes before trying to reopen the lid
otherwise the handle could be damaged.
10.Defrosting.
In order for the freezer to work to its maxi
-
mum efficiency the cabinet should be de
-
frosted when a approx. 2mm thick ice layer
has formed inside the cabinet.
The ice layer is easily removed with a plastic
or wooden scraper.
Never use a sharp metal
object which might will cause damage to
the inner liner.
The defrosting frequency is determined
mainly by two factors the usage pattern
(number of lid openings) and the relative
humidity. Excess water can be drained out
by using the drain water outlet on the front
of the freezer.
11.Cleaning.
Cleaning should be done when needed.
When used in a dirty environment it might
be necessary to remove the compressor
compartment grill, and clean the compres
-
sor compartment eventually with a vacuum
cleaner.
If the cleaning process is neglected there
is a risk that the performance of the freezer
will be effected, and even damage to the
4
Fig. 1

Содержание

Похожие устройства

Скачать