Dimplex Rothesay Brass [5/20] Maintenance

Control Knob ‘D’:- Controls the intensity of the fl ame effect.

Turning the control knob to the left increases the fl ame effect, turning the control knob to the right will

decrease the fl ame effect.

SETTING THE THERMOSTAT

Ensure the fi re is plugged in and switch it on to the full heat setting. Turn the Control Knob ‘C’ fully to the right (max

temperature setting) to warm the room rapidly. When the room temperature has reached the desired level, turn

the thermostat knob back slowly until you hear the thermostat just click off. The heater will then maintain the room

temperature at the chosen level.

Note: Should your heater fail to come on when the thermostat is at a low setting, this may be due to the room

operation.

Caution: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be

supplied through an external switching device, such as a timer, or connected to a switch that is regularly switched

on and off by the utility. Depending on room temperature and humidity upon initial start up there may be some

condensation on the inside of the stove. This can be overcome by turning the fl ame control knob down and leaving the

door of the stove slightly ajar, until the glass warms up.

GETTING THE DESIRED FLAME EFFECT

1. The fl ame control knob ‘D’ (Fig.10) may be turned up or down to give a more realistic effect.

2. Generally the fl ames appear more realistic when the fl ame control is turned down.

3. Give the fl ame generator time to react to changes you may make.

Always ensure that the appliance is sitting on a level surface.

If you intend not using the appliance for longer than 2 weeks, remove and empty the sump and water tank.

Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.

The appliance should never be operated if the lamps are not working.

The lamps should be regularly inspected as described under ‘Changing lamps’.

FILLING THE WATER TANK

When the water tank is empty, the fl ame and smoke effect shuts off and you will hear 2 audible beeps, follow these

steps.

1. Press Switch ‘A’ to (0) (See Fig.10)

2. Gently lift out the fuelbed and carefully set aside.

7. Return the tank to the sump, with the tank cap facing down and the fl at side of the tank facing outward. (Fig 8)

8. Gently place the fuelbed back into position. (Fig 9)

9. Press Switch ‘A’ to ‘ON’ (I) position (See Fig.10)

CHANGING LAMPS

If the fl ame and smoke effect appears grey or colourless it may be that one or more lamps have failed.

You can check for lamp failure as follows.

1. Leaving the fl ame effect on, lift out the fuelbed and water tank.

2. It should be possible to view the lamps with the nozzle in place and observe which one needs to be changed.

3. Put Switch ‘A’ in the ‘OFF’ position, and unplug the fi re from the mains.

4. Leave the appliance for 20 minutes to allow the lamps to cool down before removing them.