Animo MT200V+50241 [13/25] Installation

01/2009 Rev. 3.0

3.2 Installation

3.2.1 Preparation for positioning the appliance

- Position the appliance at buffet height on a firm, level base that can bear the weight

of the appliance when it is filled.

- Position the appliance level and in such a way that it cannot cause any damage if it

leaks.

- Thewatersupplypipe(G3/4”pipe15mm)andthepowerconnectionmustbe

situated within half a metre of the appliance.

- The owner must have these installation-technical preparations performed by qualified

engineers in accordance with general and local regulations.

- The service engineer may only connect the appliance to the prepared connections.

3.2.2 Electrical connection

Supply voltages and frequencies can differ between countries. Check if the appliance is

suitable for connection to the local power mains. Check if the details on the type plate

correspond. Connect the appliance to an earthed wall socket.

3.2.3 Connection to the water mains

Connect the appliance using the water hose to an easily accessible aeration tap that can

be quickly closed if problems arise.

3.2.4 Water drainage (18)

If the reservoir of the coffee maker is overfilled owing to a defect, the excessive water will

be discharged via the water drain (18) at the bottom of the appliance. Make allowance

for this when positioning the appliance!

3.2.5 First time use

When used for the first time the appliance works according to the standard factory set-

tings. The various settings can be altered by authorised personnel. See chapter 5.

Settings.

CAUTION

• Wateralwaysremainsintheheatingsystem:forthis

reason the appliance must not be placed in an area

where the temperature can fall below freezing point.

WARNING

• Ensurethatthemainsleaddoesnotcomeinto

contact with the hot plates (if present).