Animo MT200V+50241 [18/25] Settings

01/2009 Rev. 3.0

5. SETTINGS

5.1 Setting of the amount of coffee

Both the M and the MT models are supplied as standard set to make coffee using 1.8

litres of water (14 cups). If this is too much or too little, or if you are using an MT model in

combination with a thermos jug with a greater capacity, you can adjust the quantity as fol-

lows:

1. Press the selection button (5.4) and hold it in, and then press the start/stop button

(5.5) once. A number will appear in the display.

2. Release both buttons. The display will show the set value. The standard setting is

20 (1.8 l. / 14 cups).

3. Press the selection button (5.4) to increase the amount. Each increase in the display

puts approximately 4 ml more water in the jug. Use the table at the back of this

manual. To reduce the quantity: go through the table until it restarts after 50.

The range runs from 0, 1, 2, 3, 4…. 50.

4. Now wait for 6 seconds. The selected quantity is has been saved.

5.2 Setting of the display to show cups or litres

The appliance is factory set to display the number of cups.

If you want the display to show litres, you can adjust it as follows:

1. Press the selection button (5.4) and hold it in, then press the start/stop button (5.5)

once. A number will appear in the display.

2. Release both the buttons and then press the start/stop button once again.

3. A“C”(Cups)willappearinthedisplay.Changethe“C”toan“L”withtheselection

button.

4. Now wait for 6 seconds. The adjustment has been saved.

5.3 Setting of the prewet function

This appliance can make coffee using two methods:

Continue-brew(“Cb”)(factorysetting);Thecoffeemakingprocessbeginsimmediately

and will pour hot water over the ground coffee without a waiting time.

Prewet-brew(“Pb”);partofthehotwaterisfirstpouredontothegroundcoffee.This

causes the coffee to rise so that the smells and flavours are released. The coffee making

process then begins. If you want to set the appliance to Prewet brew, this setting can be

changed as follows:

1. Press the selection button (5.4) and hold it in. Then press the start/stop button once.

A number will appear in the display.

2. Release both buttons and then press the start/stop button twice.

 “Cb”(Continue-brew)willappearinthedisplay.

3. Usetheselectionbuttontochange“Cb”into“Pb”(Prewet-brew).

4. Now wait for 6 seconds. The adjustment has now been saved.

WARNING

• Thejugwilloverflowifthesetcoffeequantityistoohigh.

• Themanufacturerisunabletoacceptanyliabilityforthe

consequences of altered settings.