Liebherr ICBS 3314 [4/12] Ventilation of the kitchen unit
![Liebherr ICBS 3314 [4/12] Ventilation of the kitchen unit](/views2/1331286/page4/bg4.png)
6 Ventilation of the kitchen unit
Fig. 3
-
There must be an effective ventilation shaft of at least
200 cm
2
per appliance at the air inlet
Fig. 3 (A)
and outlet
Fig. 3 (B)
vent.
-
The principle applies that the larger the ventilation shaft, the
more energy-saving the operation of the appliance.
-
The depth of the ventilation shaft at the back of the unit must
be at least 40 mm thick.
Fig. 4
-
The upper ventilation shaft can either be positioned directly
above the appliance with an optional ventilation grille
Fig. 4 (C)
, close to the ceiling above the unit
Fig. 4 (D)
or as
an air outlet opening in a false ceiling
Fig. 4 (E)
.
7 Changing over door hinges
WARNING
Risk of injury through door dropping out!
If the fastening components are not screwed in tightly enough,
the door may drop out. This can lead to serious injury. What is
more, the door may also not close fully, so that the appliance
may not refrigerate properly.
u
Screw the bottom and top turn hinges tightly into place (with
4 Nm).
There is a risk of injury during this stage! Please
observe the safety instructions!
The instructions apply to several models. Only carry
out this step if it is relevant for your appliance.
Choose between the alternatives given.
Loosen the screws only, do not undo them all the way.
Check the screws and tighten if necessary.
u
While changing over the door hinges, observe the safety
instructions above and also the information in the symbols
key.
Change the hinges over as shown at the end
of the book.
8 Installing the appliance in the
recess
WARNING
Fire hazard from short-circuiting!
u
When pushing the appliance into the recess, take care not
to crush, jam or damage the mains power cable.
u
Do not operate the appliance with a defective mains power
cable.
There is a risk of injury during this stage! Please
observe the safety instructions!
The instructions apply to several models. Only carry
out this step if the appliance is equipped with the
corresponding feature.
Choose between the alternatives given.
Loosen the screws only, do not undo them all the way.
Check the screws and tighten if necessary.
u
Please take note of the information in the symbols key
during installation.
Ventilation of the kitchen unit
4 * Depending on model and options
Содержание
- And ventilation of the kitchen unit 2
- Contents 2
- General safety information 2
- Installing the appliance 2
- Only install connect and dispose of the appli ance according to the instructions take particular note of recess dimensions 2
- The socket must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency it must be outside the area of the rear of the appliance 2
- Transporting the appliance 2
- Appliance dimensions 3
- Depending on model and options 3 3
- Recess dimensions 3
- Changing over door hinges 4
- Depending on model and options 4
- Installing the appliance in the recess 4
- Ventilation of the kitchen unit 4
- Connecting the appliance 5
- Depending on model and options 5 5
- Disposing of packaging 5
Похожие устройства
- Fimar SPM Инструкция по эксплуатации
- Fimar SPM Каталог оборудования FIMAR
- Hallde 37178 8х8мм Инструкция по эксплуатации
- Hallde 37178 8х8мм Спецификационный лист (англ.)
- Hallde 37177 6х6мм Инструкция по эксплуатации
- Hallde 37177 6х6мм Спецификационный лист (англ.)
- Hallde 37185 20х20мм Инструкция по эксплуатации
- Hallde 37185 20х20мм Спецификационный лист (англ.)
- Hallde 37184 20х20мм Инструкция по эксплуатации
- Hallde 37184 20х20мм Спецификационный лист (англ.)
- Hallde 37179 10х10мм Инструкция по эксплуатации
- Hallde 37179 10х10мм Спецификационный лист (англ.)
- Hallde 37183 15х15мм Инструкция по эксплуатации
- Hallde 37183 15х15мм Спецификационный лист (англ.)
- Hallde 37180 12х12мм Инструкция по эксплуатации
- Hallde 37180 12х12мм Спецификационный лист (англ.)
- Cooleq S903 Инструкция по эксплуатации
- Fimar FR150P Инструкция по эксплуатации
- Fimar FR150P Каталог оборудования FIMAR
- Hallde 37181 12х12мм Инструкция по эксплуатации