MCZ Quasar [20/27] Assembly and feet adjustment

INSTALLATION AND USE MANUAL

Chapter 4

page

Installation and assembly

4.3. ASSEMBLY AND FEET ADJUSTMENT

Some models require the assembly of support feet whose purpose is to

level the stove to be well-aligned and stable. For the Wood Module, the

feet also lift the structure to prevent the decorative frame from coming

into contact with the floor. Correct adjustment requires the frame to be

about 0.5 cm above the floor.

The feet are screwed into the structure base and can be installed as

illustrated and adjusted using a screwdriver.

4.4. CERAMICS ASSEMBLY

For the assembly of ceramics for each specific wood stove model,

please see the ceramics installation manual in the latter's packaging.

Assembly instructions for the Modulo product decorative frame are

included below.

4.5. FRAME ASSEMBLY (WOOD MODULE)

For stove frame assembly, after unpacking, remove the top of the

stove, unscrewing the four screws on the top, place the frame on the

structure and continue as indicated below

PHASE 1

Near and fit the lower frame supports in the slots on the lower part of

the stove structure.

PHASE 2

Near the frame and fit the top edge of the structure so the screws

match the holes on the structure. Secure the frame with the fastening

screws as illustrated.

After levelling the last tile, make sure the cornice is fastened

correctly to the structure of the heater, checking that the

latter is firmly anchored.

Phase 2 Match the frame to the structure as illustrated and secure using the

fastening screws and bolts

Phase 1 Fit the lower frame supports on

the lower part of the structure