![Lincat J5nFL [17/17] Service](/img/pdf.png)
Lincat J5nFL [17/17] Service
![Lincat J5nFL [17/17] Service](/views2/1337693/page17/bg11.png)
17
SERVICE
Gas catering equipment should be routinely serviced to ensure a long trouble free life. With this in
mind it is recommended that the appliances are serviced every 6 months by a competent gas engineer.
For help regarding the installation, maintenance and use of your LINCAT equipment, please call:-
LINCAT SERVICE HELP DESK
01522 500881
AUTHORISED SERVICE AGENTS
We recommend that all servicing other than routine cleaning be carried out by our authorised service agents
and will accept no responsibility for work carried out by other persons. Note that for safe and efficient
operation, appliances need regular servicing.
Please quote both the model and serial numbers from the data plate attached to the unit. Give brief details of
the service requirement.
If you know the part number of the part in question, please quote this information also.
Lincat reserve the right to carry out any work under warranty during normal working hours, i.e. Monday to
Friday, 8.30 a.m. - 5.00 p.m.
CONDITIONS OF GUARANTEE
The guarantee does not cover:-
1) Accidental breakage or damage
2) Operational misuse, wear and tear from normal usage, incorrect adjustment, or neglect.
3) Incorrect installation, maintenance, modification or unauthorised service work.
Содержание
- Silverlink 600 gas fryer j5 and j10 1
- User and installation instructions 1
- Foreword 3 2
- Installation instructions 4 6 2
- Notes on frying 7 8 2
- Operating instructions 9 10 2
- Service 17 2
- Servicing 11 13 2
- Spares list 16 2
- Technical specification 16 2
- Troubleshooting 14 15 2
- Consequential loss 3
- Foreword 3
- Important 3
- Maintenance 3
- Warning 3
- Before commencing installation of the appliance please take time to read the following installation instructions carefully parts protected by the manufacturer are not to be adjusted by the installer or user 4
- Stabilising kit installation instructions 5
- After setting ensure the governor cap is properly secured and the blanking screws replaced in 6
- Anticlockwise to reduce it 6
- Fig 1 c 6
- Inlet pressure refer to technical data table on page 16 6
- Method described above to the value shown on the technical data table page 16 6
- Remove the governor cap and turn the screw clockwise to increase the outlet pressure and 6
- The test points 6
- Use the test point marked out fig 1 b to set the unit to the appropriate burner pressure 3 adjustment is made via the valve s onboard governor which is situated centrally on the valve 6
- Use the test point provided on the gas control valve marked in fig 1 a to check the supply 6
- With main burner lit refer to operating instructions page 9 adjust the burner pressure by the 6
- C before draining 7
- Notes on frying media 7
- Warning always allow oil to cool to a maximum 55 7
- A guide to frying times 8
- Frozen foods 8
- Frying tips 8
- Oil capacity 8
- A a thermostat knob b control valve c pilot d limit reset location e drain valve blanking cap f drain valve lock g drain valve handle 9
- Lighting of the appliance please ensure that the gas isolation valve for the appliance is turned to the open position before attempting to light this unit 9
- Note lids must not be used when cooking is in progres 9
- Operating instructions 9
- Cleaning instructions 10
- Drainage 10
- Preparation for use 10
- Shut down of the appliance 10
- Standby 10
- J5 j10 general service 11
- Servicing 11
- Control thermostat 12
- Disconnect the thermopile lead at the control valve 12
- Ignitor electrode and pilot jet 12
- J5 j10 component replacement 12
- Loosen the thermopile retaining nut located underneath the pilot assembly 12
- Reversal of above for reassembly 12
- Thermocouple this operation is easier if the pilot assembly is removed see above 12
- Thermopile 12
- Withdraw the thermopile from the pilot bracket 12
- Burner 13
- The burner can now be removed through the rear access opening 13
- Fault finding 14
- Models j5 and j1 16
- Natural gas g20 16
- Propane gas g31 16
- Spares list the following components are listed with the lincat reference number followed by a brief description ig14 ignitor electrode ig19 piezo igniter pi25 pilot assembly tc19 thermocouple tc20 thermopile th99 control thermostat th96 safety limit thermostat va20 gas control valve 16
- Technical data 16
- 01522 500881 17
- Authorised service agents 17
- Conditions of guarantee 17
- Gas catering equipment should be routinely serviced to ensure a long trouble free life with this in 17
- Lincat service help desk 17
- Mind it is recommended that the appliances are serviced every 6 months by a competent gas engineer 17
- Service 17
Похожие устройства
- Lincat J5nFL Каталог оборудования Lincat (англ.)
- Lincat LBM2W Инструкция по эксплуатации
- Lincat LBM2W Каталог оборудования Lincat (англ.)
- Robot Coupe CL55 рабочая станция Инструкция по эксплуатации
- Robot Coupe CL55 рабочая станция Каталог оборудования Robot Coupe
- Lincat LBR2 Инструкция по эксплуатации
- Lincat LBR2 Каталог оборудования Lincat (англ.)
- Vatten FI104XTKGMO BUILT-IN Инструкция по эксплуатации
- Vatten FI104XTKGMO BUILT-IN Сертификат
- Lincat LCG2 Инструкция по эксплуатации
- Lincat LCG2 Каталог оборудования Lincat (англ.)
- Lincat LGR2 Инструкция по эксплуатации
- Lincat LGR2 Каталог оборудования Lincat (англ.)
- Lincat LD4 Инструкция по эксплуатации
- Lincat LD4 Каталог оборудования Lincat (англ.)
- Lincat LRG2 Инструкция по эксплуатации
- Lincat LRG2 Каталог оборудования Lincat (англ.)
- Lincat LPG2 Инструкция по эксплуатации
- Lincat LPG2 Каталог оборудования Lincat (англ.)
- Sottoriva C600/3 Инструкция по эксплуатации