Bartscher 100323 [6/10] Cleaning

- 16 -

Cleaning

Before first use and after use daily, disassemble and clean pump. Stainless steel parts

can corrode. It is important to clean, rinse, sanitize, and dry these parts daily and

properly. Failure to comply with any of these instructions may void unit warranty:

1. Flush and rinse pump in a container of warm water. Place lower end of pump into

water container and operate pump until all (if any) remaining product is expelled and

only the warm water flows from the discharge tube. Then remove pump from

container of water to disassemble and use container to collect the small parts of the

pump to prevent any loss.

2. See „Pump Disassembly“.

3. Wash and scrub all parts in dishwashing detergent and warm water.

NOTE!

•

••

• A general purpose, nonabrasive cleaner may be used on hard to remove food

deposits.

•

••

• Do not use abrasive cleansers, scrapers, steel pads, steel wool, or other

cleaning tools that can scratch surfaces.

•

••

• A nontoxic glass cleaner may be used for cleaning any stainless steel parts.

4. Use supplied brushes to clean all confined areas. Fully rinse all parts with clear

water. Abrasive cleansing agents can corrode stainless steel. Fully rinsing all parts

can help prevent corrosion.

5. Sanitize parts following your local sanitization requirements.

CAUTION!

All parts in contact with food must be sanitized.

6. Allow parts to fully air dry after sanitization.

Various elements and minerals, such as chlorides in tap water, can accumulate on

stainless steel parts and create corrosion. To prevent corrosion on any stainless

steel parts, it is important to fully air dry, as required after sanitization, or to fully dry

with a clean soft cloth regularly.