Suunto Vector HR [48/61] Bearing tracking sub mode

6.1 beaRIng TRaCkIng sub Mode

The user can select to change from the cardinal point mode to the bearing tracking mode (Fig. 52).

In the compass main mode:

1. PRESS the [Select] button and hold in for 2 seconds. Located in Field 1, “OFF” will begin to ash (Fig. 53).

2. PRESS either the [+] or the [-] button to change the setting between “OFF” and “ON”.

3. At the selection desired, PRESS the [Select] button to move to the next setting. Located in Field 2, the actual bearing in degrees

will begin to ash (Fig. 54).

4. Turn the Wristop Computer to the desired direction. Lock the bearing displayed by pressing the [-] button.

5. Adjust the locked bearing, if necessary by pressing the [Select] button and then adjusting the value with the [+] and [-] buttons.

6. At the desired bearing to track, PRESS the [Mode] button to accept the changes and exit the setup program.





6.2 deClInaTIon adjusTMenT sub Mode

The Wristop Computer allows the user to compensate the difference between true north and magnetic north. This process is accomplished

by adjusting the declination, resulting in the user obtaining correct compass readings.

In the Compass mode, PRESS the [Select] button once to enter this sub mode.

In the Declination Adjustment mode (Fig. 55):

• Field 1 displays the declination direction “OFF” where OFF = no declination; W = West; E = East.

• Field 2 displays declination in degrees.

• Field 3 displays the text “dEC”.