Soundmax SM-CSA402 коаксиальная 2-полосная 10см 50Вт-100Вт [4/15] Securing the speakers

 If it will be necessary to cut steel, reinstall the cosmetic

panel in place and use the hole you have previously cut as a

template. This will help to insure proper cutting and a good

fit. Now, mark the locations for the speakers mounting

screws, remove the panel and drill the screw holes. When

finished you may replace the panel.

 After cutting and drilling all holes, inspect the mounting

areas for any metal burrs or rough edges. File any area that

may interfere with the mounting of the speaker.

 Clean any metal shavings from the mounting area and

check for areas in which water may enter the speaker cavity.

Treat the area for water protection when necessary.

Securing the speakers

 Position the speaker into the mounting hole and re-confirm the correct

mounting location and hole placement.

 Screw clips are provided to ensure a snug fit. These should be placed over

the metal surface and line up the hole you have previously drilled with the

screw clip. Place the speaker into the hole, align the holes and proceed to insert

the screws. Be sure to tighten the screws evenly so that it will not warp the

speaker frame.

 Turn your system back on and confirm the speakers operation first at a low

volume and then you may increase the volume as you desire.

 After installation acoustic system and having tested it the speaker grill will

have to be inserted. Turn on you system and follow these steps carefully:

- locate the speaker grill;

- now carefully inspect the place where the speaker grill will be mounted – there should be no blowholes;

- fix the speaker grill by screws.