Philips SENSOTOUCH 2D RQ11/50 [7/232] Charging

The three shaver types (RQ1180, RQ1160 and RQ1150) have different displays, which are shown in the gures below.

- RQ1180 (Fig. 4)

- RQ1160 (Fig. 5)

- RQ1150 (Fig. 6)



- Charging takes approx. 1 hour.



- When the shaver is charging, rst the bottom charging light ashes, then the second charging light, and so on until the shaver is fully

charged (Fig. 7).



- When the battery is fully charged, all charging lights light up continuously. After approx. 30 minutes the display automatically switches off

again. (Fig. 9)



- When the battery is fully charged, the battery symbol lights up continuously. After approx. 30 minutes the display automatically switches off

again. (Fig. 10)

Note: The displays of types RQ1160 and RQ1150 look different, but work in the same way.





- When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the bottom charging light ashes orange. (Fig. 11)



- The remaining battery capacity is indicated by the number of charging lights that are on. (Fig. 13)



You can lock the shaver when you are going to travel. The travel lock prevents the shaver from being switched on by accident.



1 Press the on/off button for 3 seconds to enter the travel lock mode (Fig. 14).

, The lock symbol lights up on the display. -tekening- (Fig. 15)

Note: The displays of types RQ1180, RQ1160 and RQ1150 look different, but show the same symbol.



1 Press the on/off button for 3 seconds.

RQ1150: A fully charged shaver has a shaving time of up to 40 minutes/12 days.

Charge the shaver before you use it for the rst time and when the display indicates that the battery is almost empty (see section ‘Battery low’

in chapter ‘The display’).



After the shaver has charged for 5 minutes, it contains enough energy for one shave.



1 Put the small plug in the charger (Fig. 16).

2 Put the adapter in the wall socket.

3 Put the shaver in the charger (1) and push it backwards (2) (‘click’). (Fig. 17)

, The display shows that the shaver is charging (see chapter ‘The display’).