Gardena smallCut 300 Accu 08844-20.000.00 [15/208] Troubleshooting

Gardena smallCut 300 Accu 08844-20.000.00 [15/208] Troubleshooting
GB
15
8. Troubleshooting
A cutting filament that is too short or no longer extends
automatically when the trimmer is turned on can be pulled out
manually.
1. Remove the battery pack.
2. Hold the automatic slide feed (21) down with your hand and at
the same time pull on the cutting filament (5).
If the cutting filament has disappeared into the filament cassette or if the
automatic filament extension still doesn’t work after pulling the cutting
filament (5) it may be fused together in the filament cassette (19).
1. Remove the battery pack.
2. Remove the filament cassette (19) as described in
6. Maintenance “
Replacing the filament cassette
”.
3. Unwind the cutting filament (5), clean the filament cassette (19)
and the cutting filament (5) and wind the cutting filament (5)
onto the cassette (19) once more.
4. Clean the automatic mechanism lever (21). The automatic lever
must move freely.
5. Insert the filament cassette again as described under
6. Maintenance “
Replacing the filament cassette
”.
Fault Possible cause Remedy
The Turbotrimmer Filament cassette empty.
Replace the filament cassette
no longer cuts (see 6. Maintenance
“Replacing the filament
cassette”
).
Cutting filament too short or the
Pull the filament out of the
automatic filament extension cassette manually.
Cutting filament inside the Release filament that has
cassette or fused. disappeared into the
cassette or fused together.
Charging indicator lamp does Battery not plugged
Plug in battery charger
not light up in properly. and charging cable
properly.
Charging indicator lamp A fault has occurred.
Unplug and reinsert
flashes for more than charging cable. The fault
1 hour will be reset.
The battery can no longer Battery is defective. Replace the battery
be charged (Art. 8834).
Risk of Injury !
Risk of injury from the cutting filament!
Always remove the battery pack of the Turbotrimmer before
troubleshooting.
Pulling the cutting filament
manually out of the
filament cassette:
21
5
Releasing a cutting filament that
has gone into the cassette or
which has fused:
5
21
19
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers authorised by
GARDENA.
Risk of injury from the filament limiter !
Keep fingers away from the filament limiter
After extending the cutting filament always return the trimmer
to its normal operating position before switching on.

Содержание

Похожие устройства

Скачать