Proform Endurance 420 E (PFEVEL49716) Инструкция по эксплуатации онлайн [10/32] 317357

10. Untie and discard the wire tie on the Main

Wire (48).

While a second person holds the Console (7)

near the Upright (4), plug the Main Wire (48) and

the Pulse Sensor Wires (63) into the matching

receptacles on the back of the Console.

The connectors on the Main Wire (48) and the

Pulse Sensor Wires (63) should slide easily

into the receptacles and snap into place. If a

connector does not slide easily into a receptacle,

turn the connector and try again. If you do not

connect the connectors properly, the console

may become damaged.

Insert the excess wire into the Upright (4) or into

the Console (7).

9. The Console (7) requires four D batteries (not

included); alkaline batteries are recommended.

Do not use old and new batteries together or

alkaline, standard, and rechargeable batter-

ies together. IMPORTANT: If the Console has

been exposed to cold temperatures, allow it

to warm to room temperature before insert-

ing batteries. Otherwise, you may damage

the console displays or other electronic

components.

Remove the screws and the battery cover from

the back of the Console (7), insert batteries into

the battery compartment, and then reattach the

battery cover. Make sure to orient the batteries

as shown by the diagrams inside the battery

compartment.

To purchase an optional power adapter, call

the telephone number on the cover of this

manual. To avoid damaging the Console (7),

use only a manufacturer-supplied regulated

power adapter. Plug one end of the power

adapter into the receptacle inside the battery

compartment on the Console and route the

power adapter through the notch in the bat-

tery cover; plug the other end into an outlet

installed in accordance with all local codes and

ordinances.

Battery

Cover